Converse of object

• withstand: Firstly, the primary winding must be able to withstand the peak primary voltage across the number of turns which are utilized.

• induce: The voltage induced in the coil is proportional to the change in flux through it ( Faraday's Law?

Adjective modifier

• nominal: Step 3: We are going to use a 3 cell lipo making the nominal voltage 11.

• analog: The reference voltage is compared against our analog input voltage.

Modifies a noun

• divider: Sometimes the voltage divider resistor will be a tapped wire-wound type.

• regulator: All panels over 18 watts will require a voltage regulator.

• waveform: A controller in the synchronous buck converter switches the FETs according to the input voltage waveform to achieve rectification.

• downlights: The advantage of low voltage 12v downlights versus 240v mains voltage downlights is a thicker filament.

• switchgear: More specialized work such as maintenance of high voltage switchgear or control system modification is almost certainly likely to require additional training and experience.

• halogen: Don't confuse low energy bulbs with low voltage halogen light bulbs.

Preposition: across

• resistor: If this test shows little or no voltage across the resistor, you're probably all set.

• capacitor: By applying a bias voltage across the capacitors, an electric field is set up within the ferroelectric, causing its permitivity to change.

Preposition: of

• volt: This corresponds to an output voltage of 40 volts.

• transformer: In practice the Static gap may be set such that its breakdown voltage is equal to the peak voltage of the supply transformer.

Noun used with modifier

• anode: The anode voltage is about 3000 volts under a load of 850 ma.

• excitation: You can adjust excitation voltage, input gain, offset nulling and output scaling.

• capacitor: The peak primary current can be found by dividing the " fully charged " capacitor voltage by the surge impedance.

• dc: Input modules sense the presence of either an ac or dc voltage, and will send a TTL signal back to the computer.

• emitter: The transistor base voltage is maintained at approx 0.6V above the output voltage required thus regulating the transistor emitter voltage.

• bias: By making the reference bias voltages applied to the diodes equal, an approximate square wave output is obtained from a sine wave input.