Converse of object

• solder: There are also some resistors soldered in mid-air rather than via the PCB.

• connect: The more sensitive the eye is to a color, the lower resistor connected to it.

• brake: One factor driving sales in recent years has been the demand for braking resistors.

• mount: A convenient point to mount this resistor is inside the 7-pin DIN plug or jack plug of the cassette lead.

• limit: I probably should add a current limiting resistor to the circuit.

• replace: I noted that somebody had replaced a resistor in one corner of the board with a pair of series 15k resistors.

Preposition: in

• parallel: This is done with a resistor in parallel to the input of 1.8k.

• circuit: Start with the variable resistors in the meter drive circuits at a mid way position.

• series: The carbon pile regulator is basically a resistor in series with the generator field coil.

Adjective modifier

• pull-down: They are terminated on BOC, but have no pull-down resistors.

• variable: A variable resistor very flowed in a manual box.

• dependent: Maybe we could do something along this line with a light dependent resistor to receive the light beam.

• fixed: One of the pots does indeed replace one of the fixed resistors whilst the other is connected the the extra PCB.

Modifies a noun

• R: In a similar fashion the load resistor R can also be placed across the switch.

Noun used with modifier

• ohm: The voltage on the left hand 10 ohm resistor is flowing out of the top terminal of the resistor.

• pull-up: Actually pin 8 is the processor reset line and has an on-board pull-up resistor.

• watt: If you use larger 1/4 watt resistors, you may need to space the transistors off the PCB slightly.

• cathode: If the IF amplifier valve has a cathode bias resistor, check it's on value.

• emitter: To find the dc collector current, measure the dc voltage across the emitter resistor and use ohm's law.

• shunt: The shunt resistor is always an unusual low value, and needs to be hand-made from resistance wire.