Converse of object

• use: I'm not using any outboard at all, just using the desk - it really does the job.

• take: Ideal for fishing or just pottering about moves well under oars and it will take a small outboard.

• have: Now I have an outboard I can trust with CDI ignition system, and which doesnt send you in circles when you start it.

Converse of subject

• power: This magnificent craft was an ally punt with a tent on top, powered by a 10hp outboard.

Adjective modifier

• electric: Not even an electric outboard will be tolerated by these fish.

• small: A set of oars or a small auxiliary outboard are advisable.

• twin: The twin outboard roared and the little craft swept around the Dolphin ' s stern and headed out to sea.

• 30hp: RIB with 30hp outboard, £ 285,000 GBP VAT paid.

• four-stroke: With a first prize of an Avon 5.5m RIB with 40hp Honda four-stroke outboard for the club of the winner.

Modifies a noun

• motor: Can I use a fresh water outboard motor in the sea?

• gear: Rack Space A standardized size of the front mounting plate in outboard gear equal to approximately 1 3/4 " tall by 19 " wide.

• engine: The outboard engine mounting board can also be seen to have retained its coating.

• equipment: The School uses Pro Tools, Cubase and Sibelius and has a large selection of professional outboard equipment, plug-ins and microphones.

• effect: Use it make notes about the song - sounds, outboard effects used, settings and so on.

• end: The mandrel carries at its outboard end a 12 " driving pulley weighing about 12 lbs.

Noun used with modifier

• Yamaha: This sytem is offered on a range of Yamaha outboards from 150hp to 200hp.

• stroke: Full details and photos will be added Hardy Pilot Red Pepper was a 20ft Hardy Pilot with a Suzuki 50hp four stroke outboard.

• hp: I recently bought a 7.5 hp merc outboard that appears to be in good condition.

• seagull: Seagull outboards seem originally to have been made by Sunbeam.

Preposition: of

• bearing: Notice the very largest backgear, just visible behind the faceplate and outboard of the front spindle bearing.