Preposition: of

• ohm: All outputs are individually buffered with an impedance of 75 ohms.

• circuit: On a bank of lamps the peak will depend on the feed impedance of the circuit.

Converse of object

• normalize: In this picture the normalized impedance of the SMITH chart is 200 ohms.

• calculate: Given the volume velocity, the PC also calculates the input impedance according to equation 2.7.

Adjective modifier

• acoustic: Therefore it is possible to directly measure the specific acoustic impedance at the cone surface.

• characteristic: Now we see why coaxial cable is often designed to have 75 ohms characteristic impedance.

• nominal: Standard structured UTP or FTP cabling systems have a nominal impedance of 100 ohms.

• electrical: Weighing people under water and measurements of electrical impedance have also been employed.

• low: The floors of the building present an extremely low impedance to water.

Modifies a noun

• mismatch: Thirdly every time the signal passes thru an impedance mismatch a reflection is generated.

• tomography: Electrical impedance tomography a new imaging technique for epilepsy All imaging methods in use today have their limitations.

• spectroscopy: New rapid toxicity testing methods based on impedance spectroscopy are being developed in conjunction with the company Kaiku.

• Z: T Adds a transmission line of characteristic impedance Z in series with the impedance in X, transforming its impedance in most cases.

• matching: At todays high speeds one should think of the cable more of a an RF device with its inherent demands on impedance matching.

Noun used with modifier

• ohm: In common with most good Yagi designs, these antennas are ' matched ' to the standard 50 ohms input impedance of radio-tracking receivers.

• input: The input impedance decided on was the industry standard of 1M W.

• output: You will be told the exact value of the output impedance.

• load: This lower load impedance being presented to the inverter causes more power to be sourced from the inverter.

• surge: The peak primary current can be found by dividing the " fully charged " capacitor voltage by the surge impedance.

• loop: Also included within this test is a polarity and earth fault loop impedance test of up to 10 % of the sockets.