Converse of object

• crank: The chassis, now further back in the workshop, showing the refitted crank axle.

• calibrate: Technical data: 27z aluminum crown, 9z bronze pinion, detailed hubcaps, steel calibrate axles and bronze calibrate bearings.

Adjective modifier

• rear: We had a rear axle fail near Bristol, early on in the ride.

• crank: The crank axle is in front of the loco.

• tandem: Axle configurations include all-wheel drive as well as single and tandem drive axles ( single and hub reduction ).

• twin: While we had no problems I find our twin axle much nicer to tow.

• broken: I personally am allergic to ' new world orders ' the broken axles of which litter the trails of history.

• front: The front beam axle is drilled for lightness with the spring going through the beam leaving the original spring mounting pad free.

Modifies a noun

• loading: Maunsell was confronted with what had become his perennial problems: increased train capacity combined with the need for a light axle loading.

• casing: I have noticed for example that on the axle casings rust appears through the paint.

• overload: It also enables a more even load distribution, reduces route planning time and risks of axle overload.

• trailer: A twin axle trailer up to 3m in length A hire van A car that is unable to fit under height barrier.

• nut: Tighten the axle nut using either a skate tool or 1/2 " socket.

• bearing: The only evidence of the axle bearings is newer brickwork in the general area where they used to be.

Noun used with modifier

• stub: None of the stub axles I have prepared in this manner have failed.

• centreplate: This page describes the third stage in fixing the problem of the loose centreplate axle.

• driving: May 01 2004 The refurbished rear driving axles springs arrived during the week.

• beam: The front beam axle is drilled for lightness with the spring going through the beam leaving the original spring mounting pad free.

• wheel: The gear linking the two wheel axles is raised slightly above center line to achieve a correct mesh distance.

• ton: The 25 ton axle load may have been just two high for industrial lines in the 1950s.